Hi,
ivms-4500 HD updated on my Android today to v3.4.3. I can now only access one of my three cams. Two give the error "no more user can be logged in". I have tried removing the config for one of these cams and reading but the same issue persists.
Anyone else having this?
Regards
Graham
With 75% recordings 25% pictures (as default), the drive is 51% used and recording now failing.
Going back to 50% each (wasteful, but I have just about enough capacity to make it work) to see how I go. Very odd issue that I am surprised is not more widely known.
So back to multiple 200GB quota NAS drives with the picture:recording ratio set to 50% and 50%. I had this set to 5% and 95% previously. This time the drive fills to just over 50% then moves onto the next drive. No recording failure.
I have now set back to the default 25% pictures, 75%...
So I have been testing with the small 10GB quota drives. I set up multiple 10GB drives on the one cam. The first drive gets to around 60% full and recordings then fail. They do not play back and the files cannot be downloaded. The recording markers are there though. The drive continues to fill...
I am not sure I have an audience with this thread, but I have now tested with a small 10GB NAS drive quota. As soon as the space got down to 3.75GB free (6.25GB consumed), I can see recording markings, but cannot play back past that point. At 4.5GB free all was OK.
So my quotas never fill up to...
One week on again and the same cam has now stopped recording. Same symptoms, I can play recordings from before the failure and I can see the indexed recordings in iVMS-4200, but there is no recording.
A week of recording then a failure is no good to me. In my desperation I will try a 150GB...
I tried a 250GB quota and one week on and 133GB used the fault occurred. Recording up to early morning today were fine, then after a certain time no playback.
So I've reduced the quotas to 199GB and have reformatted the camera drives to see if that is any better.
Thanks Kieran (and morph). My 6th sense was telling me it was quota size related, hence the info in my post. I will try what you suggest. As you say it would be interesting to see the cams fill a quoata and start overwriting.
If the quota really has to be as small as circa 200GB I also would...
I have three DS-2CD2132F-I all on firmware 5.3.0 build 150814. These all record (events only, not continuous) to separate SMB shares on a NAS with quotas set. The shares are 800GB and 2 x 515GB, recording is set to overwrite.
All is well until for some reason the recordings on one or more...