Mobotix Q24 Hemispheric IP Dome Camera MX-Q24M-Sec-D11

Questions on Mobotix Q24 Hemispheric IP Dome Camera MX-Q24M-Sec-D11

• From Bob at 29/09/2011 17:14
  • Mobotix Q24 Hemispheric IP Dome Camera MX-Q24M-Sec-D11
    
    Hi, I would like to fit one of these cameras into my shop and view remotely from my office through broadband, is this relatively straight forward to set up or would I need a 'qualified engineer'?
  • Hello Bob,
    
    It depends on your technical ability really; you need to be able to set the camera up at site on the local area network, then configure the router at site to permit you to access and view the camera (port forwarding & firewall rules), and finally be able to find your camera site on the world wide web (either by means of a fixed IP address for the camera site or using a service such as DynDNS.com to provide you with a free friendly url that tracks the site's changing/dynamic IP address).
    
    Simples!
  • Do you find this question helpful?  Yes   No
• From laurent at 06/01/2010 13:47
  • HI,
    
    What system should I install to watch my camera Q24 on a tv screen ?
    I would like to be able to have the quad view
    Any possibility to watch the playback as well?
    
    Many thanks,
    
    Laurent
  • Hi Laurent,
    
    I can't think of an easy way to do this. Mobotix Q24 is a network camera, with no HDMI output (or similar) for TV.
    You need to run the Mobotix software on a PC for quad views.
    If you have a PC with an HDMI output, then you could connect your TV to that PC and simply select that channel input into the TV when you wish to view the Q24, but the Q24 would actually be on the network, connected to the PC, which would be running the Mobotix software, and you would effectively be using your TV as a PC monitor.
    
    Hope that helps ...
  • Do you find this question helpful?  Yes   No
• From Brian at 15/10/2009 22:42
  • I thought the Mobotix Q24 was supplied with an SD card but there doesn't seem to be one supplied in the box.
  • Mobotix supply the Q24 camera with a 4GB SD card pre-installed. The 'slot' isn't normally visible. You need to remove the four screws that hold the rear cover on and remove that cover to access the memory card.
    You can upgrade to a maximum 32GB memory card.
  • Do you find this question helpful?  Yes   No